Glide shoes for S/SX 0950 as a standard injection-molded part. Steel carrier in a gliding arrangement.
The glide shoes for the series S/SX 0950 are also available immediately as a standard injection-molded part. The new standard glide shoes are manufactured from highly abrasion-resistant special plastic with low coefficients of sliding friction.
Glide shoes for S/SX 0950
cost-effective
long service life thanks to highly abrasion- resistant special plastic and large wearing volume
lower coefficient of sliding friction
easy inspection of the wear state
easy replacement with screw connection
can be used with all stay variants
Schematic illustration of a steel cable carrier in gliding arrangement with glide shoes.
Easy replacement with screw connection.
In the case of cable carriers in gliding arrangement, the gliding surfaces are exposed to particularly heavy loads and are as a rule the main wearing part. The lateral wear markings on the new glide shoes allow easy ins pection of the wear state at any time. When wear occurs the glide shoes can simply be replaced.
Easy replacement of glide shoes.
Easy inspection of the wear surfaces with wear markings.
Back to top of page
Back to news overview