|
|
|
|
IN-LINE-COVER, the alternative to bellows and link apron covers
|
|
The individual plates of the cover are made of 0.5 -1.5 mm thick spring band steel, normal steel or stainless steel, depending on the length of the specific element::
- very light (reduced weight)
- Corrosion-resistant when stainless steel is used
- Long service life
|
|
 
|
- IN-LINE-COVER with harness mechanism
|
Wherever up until now bellows or link apron cover solutions have been used to prevent entry of chips, now there is a slim, robust, cost-effective alternative.
KABELSCHLEPP IN-LINE-COVERS offer the resistance capacity of telescopic covers with less weight and lower costs.
For example, you can use IN-LINE-COVERS as a cross-beam cover on gantry machine tools to protect their vulnerable drive systems against particles and fluids. Or as an alternative to link apron covers when machine components have to move in one dimension.
With the IN-LINE-COVER, the harness mechanisms provide more even motion and very smooth operation.
Here, too, the KABELSCHLEPP SXM harness principle prevents force peaks and excessive noise generation. A construction method which has proven itself thousands of times over.
New, on the other hand, is the suspension of the plates at the central pivot point of two harnesses and guidance of the harness points on one or two guide rails.
This design saves weight, and at the same time increases stability and allows narrow lamellas. It also reduces weight significantly compared to a telescopic cover.
|
|
|
|
|
|
Your contact person
|
|
| |
|
|
|
Questionnaire
|
|
Contact us using the questionnaire to find a solution to your individual application problem
|
|
Turn-Key Systems
Back to top of page