|
These covers are used to separate two machining cells of a machining center. Thus, a tool change can be carried out in one machining cell, while work continues in the other one. The partitioning of these two machining cells has to be nearly “bulletproof“, because there are several persons working in one of them, who would be in grave danger without protection.
The vertically traversing telescopic cover DUPLEX is guided by two inside harness mechanisms. Owing to the double-construction, a high degree of puncture-proofness is achieved, which more than satisfies the requirements. Of course, this construction principle can also be employed for “normal“ covering tasks. Since the covering elements are simply suspended on the harness, very inexpensive solutions are obtained.
|
Turn-Key Systems
Back to top of page