Cable carriers

BASIC-LINE
BASIC-LINE PLUS
VARIO-LINE
TUBE-SERIES
3D-LINE
STEEL-LINE
TOTALTRAX
Turn-Key Systems
Rail Cable Carrier – RCC
Guide channels
and accessories



OnlineEngineer
Online configuration
2D/3D-Data
Spare parts list

Cables

LIFE-LINE Safety Cables
EPLAN (E-CAD-System)

Conveyors

Hinged belt conveyors
Scraper conveyors
Belt conveyors

Guideway protection

Telescopic covers
Link apron covers
Way wipers
Conical spring covers
Bellows
Roll-up covers

Machine housings

PROTECT-PANEL

KABELSCHLEPP wipers on telescopic covers keep the cover boxes clean and prevent the penetration of dirt and chips.


Welded-on and riveted-on wipers

With these types the support profile is spotwelded or riveted to the cover box.

Type MA 8 / MA 12

These wipers consist of an NBR profile vulcanized onto a steel strip.

Necessary calculated distance of the cover plates 2.5 to 3.5 mm.

• Wiper type MA 8

• Wiper type MA 12

Type MA 8S und MA 12S

Wipers MA 8 and MA 12 are covered with a protective strip for protection against hot chips.

Necessary calculated distance of the cover plates 3.5 to 4 mm.

• Wiper type MA -S

Type MA 12.1 und MA 18

A specially-milled steel plate profile is spot-welded to the boxes and a PUR wiper lip is inserted.

Necessary calculated distance of the cover plates 3.5 to 5.5 mm.

• Wiper type MA 12.1

• Wiper type MA 18

Steel plate wiper made of spring band steel

A specially shaped, approximately 0.4 mm thick, approximately 25 mm wide band of stainless spring band steel is spot-welded to the cover plate. This wiper is recommended for dry machining.

Necessary calculated distance of the cover plates 1 mm.

Types with replaceable wiper lips – the new generation

The replaceable wiper with a PU lip

This new generation of wipers can be replaced directly on the machine, without disassembling the telescopic cover. The wiper consists of four parts: a retaining section of steel, a wiper lip of PU, a spring profile of plastic and a fastening pin.

By rotating the fastening pin through 90°, the wiper system is fastened to the cover plate, or loosened from it. The spring profile generates a defined pressure. Necessary calculated distance of the cover plates 5 to 5.5 mm.

The replaceable wiper made of steel

Here a solution has been developed that makes the above-mentioned spring band steel wipers replaceable. A specially-shaped support plate is spot-welded to the box. The wiper can then be pushed in. The spring force of the support plate holds the wiper in place. The holding forces are increased by defined fixing points.

Necessary calculated distance of the cover plates 1 mm.

Telescopic covers

Features
Telescopic covers with
harness mechanisms
Designs
Wipers
Damping elements
Splash- and hose-proof
protection
Rollers and sliders
Technical information
regarding design

New developments

DUPLEX, the vertically
traversing cover

CROSS-COVER, the
ready-to-install solution

IN-LINE-COVER, the
alternative to bellows
and link apron covers

Download pdf-Datei

Your contact person

Questionnaire

Contact us using the questionnaire to find a solution to your individual application problem